The model is also auto-centered if it does not fit in the print volume.Ī list of commands to use as material set-up. This value can be referenced via the $extrudertemperature$ template in the pre-commands.Ī Boolean value (0 or 1) indicating whether the model should be centered on the print bed (on the XY plane). The temperature in degrees Celsius the extruder/hot end should heat to when extruding. This is a tuning parameter and should always be near 1.0. If this factor is greater than 1.0, less plastic will be extruded. It is applied as a ratio of the incoming filament cross-section (based on filamentdiameter) to adjust the speed of extrusion. For example, 1750 is standard 1.75mm filament.Ī factor that adjusts the flow of filament. The diameter in microns of the filament loaded in the 3D printer. This value can be later referenced via the $platformtemperature$ template in the pre-commands. A value of 0 means the bed should not be heated. The temperature (degrees Celsius) the print bed should be heated to during printing. This setting is being deprecated in favor of generic materials specified by name and color. Type of material, as defined in Print Schema Keywords for 3D Printing (for example, "psk3d:PLA"). RGB or RGBA color for the material rendering in the 3D Print Dialog. This can be any string that shows up in the 3D Print Dialog for user assignment. If not specified, the drivers will assume a single extruder printer. This setting controls how many of the subsequent psk3d:Material sections in the XML will be sent to the print dialog as Print Capabilities. This allows support for 3D printers where (0, 0) is in the center of the bed (typical for Delta printers) or printers where (0, 0) is not in the front left corner of the print bed. X and Y offset of the print volume relative to (0, 0). The volume should represent the capabilities of the physical device, as one of the tests in the certification phase when publishing the driver ensures the printer can use the declared volume. Print volume in microns, defined by width (x max), depth (y max), and height (z max). Slicer settings (XML path) Setting (XML path) These settings also control Microsoft 3D Slicer (MS3DPrinterRenderFilter.DLL and dependencies) running parameters. The configuration file XML contains a number of settings that need to be adjusted for a specific 3D Printer device to control the print capabilities exposed to the 3D Print Dialog in Windows.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |